Water heater leaking: where it comes from and what to do
A water heater leak comes from one of four places: the pipe fittings on top, the temperature and pressure relief valve, the drain valve near the bottom, or the tank itself. Leaks at fittings and valves can usually be repaired, while water seeping from the tank body means the heater needs to be replaced. Start by closing the cold water valve above the heater and turning off its gas or power.
Make it safe and shut it down
If you smell gas near the heater, leave the home right away and call your gas company or 911 once you are outside. Do not flip switches or try to find the leak yourself.
With no gas smell, take these steps in order:
- Water. Close the cold water valve on the pipe that runs into the top of the heater. If it will not turn or the leak is heavy, close the main water valve for the house.
- Gas heater. Turn the gas control knob on the front of the heater to off, or to the pilot setting if you want to keep the pilot lit.
- Electric heater. Switch off its double breaker at the panel, but only if you can reach the panel from a dry spot.
The water inside the tank stays hot for hours. Keep hands away from the drain valve and the relief valve pipe until it cools.
Dry it, then watch where the water returns
Wipe the tank, the pipes above it and the floor completely dry. Lay a few sheets of paper towel on the floor around the base. Then look closely at each spot below over the next half hour or so. Fresh water gathers first where the leak begins, then runs down the side of the tank, so a puddle at the base does not prove the tank is the problem.
One harmless cause is worth ruling out. A gas heater that has just refilled with cold water can form condensation inside the burner area, which drips and sometimes hisses on the flame. It usually stops once the tank is fully hot. Steady water days later is a real leak.
What each leak point usually means
Top of the tank. The cold inlet and hot outlet connections can loosen or corrode, especially where copper meets a steel fitting. A drip here is often fixed by tightening or replacing a fitting or a flexible connector.
Relief valve and its pipe. The temperature and pressure relief valve lets out water when heat or pressure inside the tank climbs too high. Water from its discharge pipe can mean the thermostat is set too high, pressure in the house is high, or the valve is worn. Never plug or cap this pipe. A plumber can test the pressure and replace the valve, and may suggest an expansion tank.
Drain valve. The small valve near the bottom can drip if it was left slightly open or its seal has worn. Make sure it is turned fully closed by hand. A worn valve can be replaced, often without replacing the heater.
The tank itself. Water seeping through the steel shell, rust streaks or a wet spot under the insulation means the inner lining has corroded through. That cannot be patched.
Repair or replace
Fittings, connectors, the relief valve and the drain valve are parts, and a licensed plumber can swap them. A leak from the tank body is the end of that heater, and so is a tank with heavy rust at the base. Age matters too: tank water heaters commonly last around 8 to 12 years, and the year the heater was built is often coded in the serial number on its label. If yours is near that range, ask whether a new part still makes sense.
If water has spread across the floor, our guide to water in the basement covers drying out the space.
Catching the first drip
Most heater leaks start small and stay hidden in a utility room for weeks. A leak sensor on the floor beside the tank sends an alert at the first drop, and some setups also close a valve on their own. Strech, the home operating system, is built to read sensors like these and connect the home with a vetted local plumber, with the price shown before any work starts.
Questions people ask
Is a leaking water heater dangerous?
The water can be scalding, and a gas heater adds the risk of a gas leak. Shut off the water and the gas or power, and leave at once if you smell gas.
Can I still use hot water if my water heater is leaking?
It is better not to. Keep the cold valve closed and the heat source off until a plumber has looked at it, so the leak does not grow.
Why is water coming out of the pipe on the side of my water heater?
That pipe belongs to the relief valve. It drains water when temperature or pressure runs too high, or when the valve is worn. Have it checked rather than blocking it.
How do I know if my water heater tank is cracked?
If the fittings, relief valve and drain valve are all dry but water keeps appearing at the base, the tank is the likely source.
Related
Updated November 17, 2026 · Strech Inc., Montgomery County, Maryland