Toilet keeps running: how to find the cause
A toilet that keeps running is almost always leaking water from the tank into the bowl through a worn flapper, or overfilling because the float is set too high. Lift the tank lid and you can usually see which one it is in a minute. Both are common do it yourself fixes, and fixing them quickly keeps your water bill from creeping up.
Look inside the tank
Take off the tank lid and set it somewhere safe, since it is heavy and breaks easily. You will see three main parts:
- The flapper, a rubber seal at the bottom that lifts when you flush.
- The fill valve, the tall part on one side that refills the tank, with a float on it.
- The overflow tube, an open pipe in the middle that sends extra water into the bowl.
Flush and watch the whole cycle. Where the water goes tells you what is wrong.
Water spilling into the overflow tube
If water keeps trickling over the top of the overflow tube, the float is set too high and the fill valve never shuts off.
- On a float cup that slides on the fill valve, turn the adjustment screw or squeeze the clip and slide the float down.
- On an older float ball on a metal arm, bend the arm slightly down or turn its adjustment screw.
The water should stop about an inch below the top of the overflow tube. Many tanks have a fill line marked inside. If the level is right and water still runs, the fill valve itself is likely worn and should be replaced.
Water leaking past the flapper
If the water level drops on its own and the tank refills every so often with a short hiss, water is slipping past the flapper. This is sometimes called a phantom flush.
To confirm it, add a few drops of food coloring to the tank, wait about 15 minutes without flushing, and look for color in the bowl.
To fix it:
- Check the chain first. It should have a little slack. Too tight holds the flapper open; too long can get trapped under it.
- Turn off the supply valve behind the toilet, flush to empty the tank, and wipe the flapper seat clean.
- If the rubber is stiff, warped or slimy, replace the flapper. Bring the old one to the hardware store so the new one matches, since sizes and styles vary.
When a licensed plumber makes sense
Call a licensed plumber if the shutoff valve behind the toilet will not turn or leaks when you touch it, if you see a crack in the tank or bowl, if water collects on the floor around the base, or if you replaced the parts and it still runs. Water at the base usually means the seal under the toilet has failed, and that needs the toilet pulled and reset.
A toilet that ran for weeks before anyone noticed is also a common reason behind a surprise bill. Our guide to a high WSSC water bill explains how to check the meter and ask about an adjustment.
How a smart home spots a running toilet
A running toilet is easy to miss in a bathroom nobody uses much. A smart water monitor sees a small, steady flow at hours when the house should be quiet and sends an alert. A leak sensor on the floor behind the toilet catches the moment an overflow or a failed seal puts water on the floor. With Strech, the home operating system, an alert like that will turn into a visit from a vetted local plumber, with the price on your screen before the job starts.
Questions people ask
Why does my toilet run for a few seconds every so often?
That is usually a phantom flush. Water leaks slowly past the flapper, the level drops, and the fill valve tops it back up. A new flapper usually solves it.
How much water does a running toilet waste?
It depends on how bad the leak is. A slow seep may go unnoticed for months, while a toilet that runs constantly can waste hundreds of gallons a day.
Can I just turn off the water to the toilet until it is fixed?
Yes. Turn the supply valve behind the toilet clockwise to close it. Open it again only when you need to flush.
Do I need to replace the whole toilet?
Rarely. A flapper or fill valve fixes most running toilets. Replacement makes sense mainly when the tank or bowl is cracked.
Related
Updated November 19, 2026 · Strech Inc., Montgomery County, Maryland